ALINCO

DR-235T/EMKIII 25W FM Mobile/Base unit

EJ-41U internal TNC board is available as an option for 1200/9600bps packet
EJ-47U digital voice F1E board available as an option
+/-2.5ppm Frequency stability with TCXO circuit
25 watts, H/M/L power settings
100 memory channels.
Front panel data port
Rear panel DSUB9 computer connection
No need to remove mic for packet operation
Ignition key on/off feature
CTCSS, DCS encode+decode, DTMF encode and Tone-burst are all standards
Clean, clear Alinco audio
Super-wide 7 character alphanumeric display
Wide and narrow FM modes (16K0 & 8K50F3E)
Theft alarm feature
A large, palm-fitting commercial-grade backlit microphone with a metal connector (not a mudular plug)
Stays in mode you select (voice/packet) through power off cycles
Ten autodial memories
and more....at Low Alinco price!

Specifications

Genaral
Frequency range:	TX: 222.000 - 224.995 MHz RX: 216.000 - 279.995MHz
Operating mode:	16K0F3E (FM)/8K50F3E (Narrow-FM)
Channel steps:	5, 8.33, 10, 12.5, 15, 20, 25, 30, 50 KHz
Memory channel:	100 channels + 1 quick recall (CALL)
Antenna impedance:	50ohm unbalanced
Microphone impedance:	2K ohm
Frequency stability:	+/- 2.5ppm
Rated voltage:	13.8V DC +/- 15% (11.7-15.8V)
Current:	Transmit: approx. 8.0A Receive: approx. 600mA (Max) 400mA (Squelched)
Operating temperature:	-10digC to +60digC (+14digF to 140digF)
Ground:	Negative ground
Dimensions (w/o projection):	142(W) x 40(H) x 174(D) mm 5.59"(W) x 1.57"(H) x 6.85"(D)
Weight:	Approx. 1.0Kg (35.3oz)
Transmitter
Power Output:	25W(HI) 10W(MID) Approx. 5W(LOW)
Modulation system:	Variable reactance
Spurious emission:	Less than -60dB
Maximum frequency deviation:	+/- 5 KHz (FM) / +/- 2.5 KHz (NFM)
Receiver
Receive system:	Double-conversion superheterodyne
Sensitivity (-12dB SINAD):	-12.0 dBu (0.25uV) or less
Intermediate frequency:	1st IF 30.85MHz, 2nd IF 455 KHz
Squelch sensitivity:	-16.0 dBu (0.1 uV)
Selectivity (-6 dB):	12 KHz or more 6 KHz or more (Narrow mode)
Selectivity (-60 dB):	28 KHz or more 14 KHz or more (Narrow mode)
Audio output power:	2.0 W (8 ohm, 10% distortion)
Product intended for properly licensed operators.Permits required for MARS/CAP use. Specifications subject to change without notice or obligation. Performance specifications only apply to amateur bands. APRS is a registered trademark of Bob Bruninga, WB4APR.